Multiquip DCA85usJ2 manual Automatic Scan on

DIAGNOSTIC DISPLAY

11.Touch the “Enter Button” to deselect the selected parameter removing it from the list of parameters being displayed on the 1-up display.

ENGINE SPEED	1
PERCENT LOAD AT CURRENT RPM 3
ENGINE OIL PRESSURE	2
ENGINE COOLANT TEMPERATURE

12.Use the “Arrow Button” to scroll and highlight the desired parameter that has not been selected for display.

ENGINE SPEED
PERCENT LOAD AT CURRENT RPM 2
ENGINE OIL PRESSURE	1
ENGINE COOLANT TEMPERATURE	Note that the numbers
	now indicate the new order
	of display for the parameters.

16.Touching the “Enter Button” toggles the “Automatic Scan” function on.

USE DEFAULTS

CUSTOM SETUP

AUTOMATIC SCAN ON

17.Touching the “Enter Button” again toggles the “Automatic Scan” function off.

USE DEFAULTS

CUSTOM SETUP

AUTOMATIC SCAN OFF

13.Touch the “Enter Button” to select the highlighted parameter for inclusion in the Single Engine Parameter Display.

ENGINE SPEED

PERCENT LOAD AT CURRENT RPM 2

ENGINE OIL PRESSURE1

ENGINE COOLANT TEMPERATURE 3

14.Continue to scroll and select additional parameters for the custom 1-up Display. Touch the “Menu Button” at any time to return to the “Custom Setup” menu.

15.Automatic Scan- Selecting the scan function will cause the 1-Up Display to scroll through the selected set of parameters one at a time. Use the “Arrow Buttons” to scroll to the “Automatic Scan” function.

USE DEFAULTS

CUSTOM SETUP

AUTOMATIC SCAN OFF

18.Once the “Use Defaults”, “Custom Setup” and “Automatic Scan” functions have been set touch the “Menu Button” to return to the main menu.

USE DEFAULTS

CUSTOM SETUP

AUTOMATIC SCAN ON

19.Touch the “Menu Button” to exit the Main menu and return to the engine parameter display.

GO TO 1-UP DISPLAY
STORED CODES	0		1500		3000
SETUP 1-UP DISPLAY			1800 RPM
ENGINE CONFG
SETUP-4-UP DISPLAY
SELECT UNITS				COOL TEMP
		ENG RPM
ADJUST BACKLIGHT

DCA85USJ2 60 HZ GENERATOR • OPERATION AND PARTS MANUAL — REV. #1 (03/22/11) — PAGE 29