Multiquip DCA85usJ2 manual Active Fault Codes

DIAGNOSTIC DISPLAY

!Indicates Auxiliary Gage Fault

!Indicates Fault Warning

!Indicates Derate or Shutdown Condition Fault

5.Touching the “Enter Button” will redisplay the hidden fault. Touching the “Enter Button” once again will hide the fault and return the screen to the single or four parameter display. NOTE:The fault can only be cleared by correcting the cause of the fault condition.

1 of x

ENGINE OIL PRESSURE

GAGE NOT RESPONDING

HIDE

Active Fault Codes

1.During normal operation the single or four parameter screen will be displayed

125°F		98%	1000 RPM
	1000 RPM
COOL TEMP	ENG RPM	LOAD RPM	ENG RPM
143°F	57 PSI
		14.2	57 PSI
OIL TEMP
	OIL PRES	BATT VOLT	OIL PRES

2.When the PowerView receives a fault code from an engine control unit the single or four parameter screen will be replaced with the “Active Fault Codes” message.

1 of x WARNING

SPN110 FMI10

HIGH COOLANT TEMP

MORE HIDE

3.If the word “MORE” appears above the “Arrow Buttons”, there are more active fault codes that may be viewed. Use the “Arrow Buttons” to scroll to the next “Active

Fault Code”.

1 of x

SPN110 FMI10

HIGH COOLANT TEMP

MORE HIDE

4.To acknowledge and “Hide” the fault and return to the single or four parameter display touch the “Enter Button”.

1 of x

SPN110 FMI10

HIGH COOLANT TEMP

MORE HIDE

5.The display will return to the single or four parameter display but the display will contain the “Active Fault” warning icon.Touching the “Enter Button” will redisplay the hidden fault.

				!	98%		1000 RPM
0	1500		3000		LOAD RPM		ENG RPM
	1800 RPM					!
					14.2		57 PSI
ENG RPM		COOL TEMP!			BATT VOLT		OIL PRES	!

6.Touching the “Enter Button” once again will hide the fault and return the screen to the single or four parameter display.

1 of x WARNING

SPN110 FMI10

HIGH COOLANT TEMP

MORE HIDE

7.The Single or Four parameter screen will display the fault icon until the fault condition is corrected. NOTE: Ignoring active fault codes could result in severe engine damage.

GO TO 1-UP DISPLAY	98%		1000 RPM
STORED CODES
		LOAD RPM	ENG RPM
ENGINE CONFG
SETUP 1-UP DISPLAY
SETUP-4-UP DISPLAY
SELECT UNITS	14.2		57 PSI
		BATT VOLT	OIL PRES
ADJUST BACKLIGHT

PAGE 24 — DCA85USJ2 60 HZ GENERATOR • OPERATION AND PARTS MANUAL — REV. #1 (03/22/11)