Homelite HG5000 Cleaning the Exhaust Port and Muffler, Spark arrestor, Transporting

maintenance

CLEANING THE EXHAUST PORT AND MUFFLER

Depending on the type of fuel used, the type and amount of lubricant used, and/or your operating conditions, the exhaust port and muffler may become blocked with carbon deposits. If you notice a power loss with your gas-powered products, you may need to remove these deposits to restore perfor- mance. We highly recommend that only qualified service technicians perform this service.

spark arrestor

See Figures 15 - 16.

The spark arrestor must be cleaned or replaced every 50 hours or yearly to ensure proper performance of your product. Spark arrestors may be in different locations depending on the model purchased. Please contact your nearest service dealer for the location of the spark arrestor for your model.

To clean the spark arrestor:

Remove the four hex head bolts that secure the muffler outlet cover plate.

Remove the heat shield.

Remove the screw that secures the muffler outlet cover and spark arrestor.

Pull the spark arrestor out of the muffler outlet.

Clean the spark arrestor with a wire brush.

Reinstall the muffler outlet cover and spark arrestor, and tighten the screw.

Reinstall the shield and the four hex head screws. Tighten the screws securely.

draining fuel tank/carburetor

See Figures 17 - 18.

To help prevent gum deposits in the fuel system, drain the fuel from the tank and carburetor before storing.

Draining the fuel tank

Turn the engine switch off ( O ).

Turn the fuel valve to the OFF position.

Remove the fuel line from the petcock by squeezing the ends of the retaining clip and sliding the fuel line off.

Install one end of a drain line over the petcock, and place the other end in a fuel container large enough to catch the fuel being drained from the tank.

Turn the fuel valve to the ON position.

When the fuel has drained from the tank, close the fuel valve and reinstall fuel line on petcock.

draining the carburetor

Turn the engine switch off ( O ).

Turn the fuel valve to the OFF position.

Position a suitable container under the carburetor drain screw to catch fuel; loosen the screw.

Allow fuel to drain completely into container.

Retighten drain screw.

NOTE:  Consult hazardous waste management guidelines in your area for the proper way to dispose of used fuel.

Transporting

Turn engine switch OFF ( O ).

Turn the fuel valve to the OFF position.

Make sure engine and exhaust of unit is cool.

Empty the fuel tank.

Do not drop or strike unit or place under heavy objects.

Page 15 — English