Husqvarna 5118761-06 manual USE Gloves, Annually Carry OUT the Following

Starting and Stopping

1.Place the mower on a flat surface free from grit,

gravel, etc. Fill the tank with unleaded petrol, do not mix with oil. (K)

2.Do not fill with petrol while the engine is running. Any petrol spillage should be hosed away with water. Take care that water does not enter the engine.

3.Connect the spark plug lead.

Throttle Control (if fitted)

Move the Throttle Control to the FAST ‘+’ position before starting (L).

1.Starting the cold engine

Push primer bulb firmly 3 times before starting cold engine. (Also, if the engine has stopped

because it has ran out of fuel, refuel engine and push primer 3 times).(M)

2.Starting the warm engine

NOTE: Priming is usually unnecessary when restarting a warm engine. However, cool weather (550F/130C or below) may require priming to be repeated.

3.Pull the Operator Presence Control all the way to the upper handle before you start the engine.

The lever must be held in position to keep the engine running. (N)

4.Releasing the Operator Presence Control will stop the engine within 3 seconds.

5.Start the engine by pulling the starting handle firmly upwards. (P)

6.Stopping the engine

Release the Operator Presence Control.

Use

Due to engine lubrication limitations, the mower should not be used on slopes in excess of 300.. (Q) Before mowing objects such as twigs, toys and

stones should be removed from the lawn. (R) Avoid running the blade over foreign objects such

as stones, roots, etc., as it may cause engine damage.

Mow the lawn twice weekly during the most active periods of growth.

Never cut more than 1/3 of the length of the grass, especially during dry periods. (S)

Mow with a high cutting height setting the first time. Examine the result and lower the mower to the desired setting. Mow slowly or mow the grass twice if it is very long.

Maintenance

Always remove the spark plug lead before repair, cleaning or maintenance work.

All nuts, bolts and screws should be checked for tightness after 5 hours use.

Check the oil.

Push the handle down to ground level when tilting the mower for cleaning purposes. This will avoid oil and fuel spillage.

Regularly

1.Hose down or brush off all grass, leaves, etc., from the mower. (T)

2.Check the oil level.

Always handle the blade with care - sharp edges could cause injury.

USE GLOVES

Renew your metal blade after 50 hours mowing or 2 years whichever is the sooner - regardless of condition.

If the blade is cracked or damaged replace it with a new one.

ANNUALLY CARRY OUT THE FOLLOWING:

1.Sharpening and balancing the cutter blade.

Remove the spark plug lead. Remove the cutter blade and take it to a service workshop for sharpening and balancing. When reassembling the blade ensure that the

retaining washer is flat and not dished, tighten the bolt to a torque of 35-40 Nm. (V)

2.Change the oil after each season or after 25 hours. Run the engine until warm. Remove the spark plug lead. Remove the blade to gain access to the oil drain plug, open the drain plug

underneath the mower and let the oil run out. Refit the plug and fill with new oil, SAE 30. (W)

3.The engine brake cable should always be adjusted to stop the engine within 3 sec.

CAUTION! For adjustment contact your authorized service dealer. (X)

4.Remove cover and take out the air filter.

(Z1 & Z2)

5.Clean the filter with warm, soapy water and dry thoroughly. Add 2-3 spoons of oil, distributing

evenly throughout the filter.

Transport

Remove the spark plug lead

Loosen the wire/cable from the handle before carefully folding it.

Avoid damaging the wire/cable Empty the petrol tank.

The machine must be drained of oil and fuel when moving it by public transport.

Service

When ordering spare parts, always quote the mower’s product number. Always check oil level after service.

At the End of the Mowing Season

1.Replace blade, bolts, nuts or screws, if necessary.

2.Clean your lawnmower thoroughly.

3.Ask your local Service Centre to clean the air filter thoroughly and carry out any service or repairs required.

4.Drain engine of oil and petrol.

ENGLISH - 3