SET MODULE {slot} NETWORK {ethernet_1} {ethernet_2} {ethernet_3} {isolated}
To assign a specific connector (bank of 12 ports) to a network, use the following management command:
SET MODULE {slot} CONNECTOR_{1}_NETWORK {ethernet_1}
{2} {ethernet_2} {ethernet_3} {isolated_1} {isolated_2}
Note: Assigning one connector to ISOLATED_1 and the other connector to ISOLATED_2 creates two isolated
Enabling Remote Diagnostics Mode
When used with a 3Com
Refer to the
To enable remote diagnostics mode for a specific port, use the following management command:
SET PORT {slot.port} MODE {remote_diagnostics} | {slot.port} |
{non_remote_diagnostics}
Installing and Operating the Module 3 - 21