3Com CM 4000 Default sets may vary confirm by creating a new set!

Configurator
CP Output Set
5−85CM 4000 Installation and Operating Manual
Note: If an output is permanently assigned to a CP 3010 button, but that output is later removed from the
CP Output table and the new set downloaded, the CP 3010 will continue to display the name of the out-
put until the output is manually deleted. This is done by selecting an output that is not defined and press-
ing the appropriate TAKE key on the expansion panel.
CP 3800 − When in Multiple Destination mode, CP 3800 outputs can be assigned to the soft keys dynamically,
by the operator (see page 6−34). However, by entering a soft key button number from 1 to 80 (8 buttons x 10 pages)
in the “Button” column the output will be assigned permanently to the desired button. Such assignments cannot
be changed using the panel itself.
CP 3810 Expansion Panel − By entering an expansion button number from 1 to 80 (8 buttons x 10 pages) in the
Button column, the output will be assigned permanently to the desired button.
When finished, skip to Step 17.
10. CP 320, CP 328, CP 3808, CP 3830
a. Enter the desired Category. This can be done by double−clicking on the appropriate field in the Category column;
this will open a pull−down menu of categories. Click on a category and press ENTER.
The 16−category factory default set used for the CP 3808 panel is as follows:
Default sets may vary —
confirm by creating a new set!
VTR CAM SAT EJ
VCR NET REM FILM
Studio MISC AUX FS
CGEN TEST PTCH STILL
The 16−category factory default set used for CP 320 and CP 328 panels is as follows:
VTR CG NET VCR
CAM AUX EJ SS
REM FILM PTCH STU
TEST SAT FS MISC
The 15−category factory default set used for CP 3824 panel is as follows:
VTR CG NET VCR CAM
AUX SS REM FILM PTCH
STU TEST SAT FS MISC
The 12−category factory default set used for the CP 3830 panel is as follows:
VTR GFX Studio
ENG REM NET
EC POST Xmsn
AUX TEST NUM
Guidelines for using the editor are found on page 5−3.