CM 4000 / AccuSwitch
G−2 CM 4000 Installation and Operating Manual
Thomson Broadcast Automation
Harris (Louth) Automation
Encoda Systems (formerly Columbine JDS/Enterprise Systems)
It is anticipated that additional automation systems will be qualified in the near future for control of the CM 4000 module.
For more information, please contact Grass Valley.
CM 4000/ACCUSWITCH HARDWARE INSTALLATION
Depending on the particular application, a media converter or hub may be needed to connect the Jupiter file server LAN card
to the CM 4000 or to a Jupiter VM/SI 3000. The CM 4000 has a 10/100baseT rear panel connector; the VM/SI 3000 has a
10base2 (BNC) rear panel connector.
Figure G−2. Example of Jupiter AccuSwitch installation.
CM 4000 Control Module
with AccuSwitch application
CC 2010 Matrix (Crosspoint bus)
cables.
House SMPTE
time code required
for deterministic
switching
Binary protocol
Crosspoint bus port
For jumper and switch
setting information,
refer to the Venus
installation manual.
Media converter
or Hub
Serial Port
House sync
required for
vertical
interval
switching.
Jupiter file
server
10/100baseT
Jupiter LAN
10base2
Jupiter LAN
Time host option
(backup in case of loss
of SMPTE time code)
VM 3000
CB 3000 Control Buffer
May be required when more than 50 matrix
boards are installed in switcher.
Venus,
Trinix, or
Mars router
Note: VM/SI 3000 is not compatible
with Jupiter XPress application
Automation
System
Connection to Automation System
For cabling details, please refer to the drawings starting on page 2−89.