Introduction
1−9CM 4000 Installation and Operating Manual
Specifications
Note: Some functions are extra−cost options. For more information, see the software package table beginning on page 1−27.

ELECTRICAL

CM 4000 CONTROL MODULE
Front panel controls:
Activate
Reset
Video output: Up, Down, Next, Select
Front panel indicators:
Power supply status (+3 V, +/−5 V, +/−12 V)
Active
System status (7−segment LED)
Front panel connectors
1, Probe (diagnostic) (9−pin D female)
Rear panel connectors
1, Video Out (VGA) (15−pin HD female)
1, SMPTE Time Code In (XLR female)
1, Sync (reference), 1 V P−P to 4 V P−P, looping (BNC)
1, Alarm (SMPTE 269M−1999)
8, Serial Ports (RS−422/ESbus) (9−pin D female)†
1, Redundant (control) (15−pin D female)
1, Grass Valley router Crosspoint (XPT) bus, looping (15−pin D female)
2, Aux (not implemented)
1, LAN (10/100baseT) (RJ−45)
2, USB (not implemented)
Power requirements: 100 to 240 VAC 50−60 Hz auto ranging, 0.4 A
Environmental: Operational range 0 degrees to 40 degrees C, max. 95% humidity (non−condensing)
† See page 2−12 for restrictions on use of these ports for “remote” (serial) switcher control.