Control Panel Operation CP 3830
6−96 CM 4000 Installation and Operating Manual
MENU FUNCTIONS
Destination Mode — Press MENU Once
In this mode (already described on page 6−89) the destination is shown in the Preset window. (The CP 3830P will show two
destinations.) If the panel is equipped with a CP 3809 Expansion, the outputs controlled by that panel will be indicated.
To return to Home mode, press CLEAR.
Status Mode — Press MENU Twice
This mode allows the six level buttons to select and status each level.
To return to Home mode press CLEAR. (In Home mode, the six level buttons are used for splits and the UP and DOWN but-
tons are used for source selection)
Audio Mode — Press MENU Three Times
Note 1: Audio status mode can only be used if an appropriately configured Venus switcher is connected.
This mode is accessed by pressing MENU three times; the MENU button will light in red. The Current window will show
the audio mode for the audio channel shown in the Preset window. In Figure 6−127, the Left audio channel is set to “Normal.”
Figure 6−127.
LEFT NORMAL 23
45
789
0
6
1
VTR CG NET
VCR CAM SAT
TEST NUMAUX
FILM PATCH STU
Menu
Lock
Prot
Clear
Chop
Take
VIDEO LEFT RIGHT AES1 T/C
CURRENT
PRESET
CP 3830
Other possibilities are:
MIX − Left and right are mixed on this channel.
REVERSE − Signal is from the opposite channel.
The six level keys can be used to check other levels.
Note 2: You cannot change settings in Audio Status mode; this must be done using Audio Switching mode. See
page 6−98.