Control Panel Operation
CP 3808
6−65CM 4000 Installation and Operating Manual

DESTINATION (OUTPUT) SELECTION

23
45
789
0
6
1
VTR CAM SAT
VCR NET REM
TEST PTCHCGEN
Stu MISC AUX
EJ
FILM
FS
STILL
Take
Clear
Menu
CP 3808
PRESET
Figure 6−102.
STUDIO−A
Press once to show current destination in Preset window.
VTR−01−VVTR−01−LVTR−01−RVTR−01−T
To select a destination:
1. Press the MENU button once.
The Preset window will display the present destination.
Note: If the MENU button does not blink, the destination cannot be changed—probably because the panel has
been limited to a certain output by the CP Output set used on the MPK Devices table. See page 5−112.
2. Select a new destination by
— pressing a category (e.g., “VTR”) and unit number combination, or by
— using the UP and DOWN arrows to scroll through all available destinations, or by
— pressing a category key and using UP/DOWN to scroll through the available units in that category; or by
— selecting a destination on the CP 3809 Expansion Panel (if so equipped—see Figure 6−104).
If the output has been locked* by another panel, the TAKE button will blink red. To continue, the output must be un-
locked (by the panel used to set the lock).
For additional protect/lock information − see page 6−12.
3. When the desired destination is displayed in the Preset window, press the TAKE button to select it.
To verify the new output, press MENU again. To return to Home mode, press CLEAR.