Control Panel Operation
CP 3830
6−89CM 4000 Installation and Operating Manual

DESTINATION SELECTION

Figure 6−120.
Press once,
then select
new output
23
45
789
0
6
1
VTR CG NET
VCR CAM SAT
TEST NUMAUX
FILM PATCH STU
Menu
Lock
Prot
Clear
Chop
Take
VIDEO LEFT RIGHT AES1 T/C
CURRENT
PRESET
CP 3830
COLORBAR
OUTPUT
To select a destination:
1. Press the MENU button once. The Preset window will display the present destination.
On a CP 3830P auto preview panel, the Preset window will display the Preset (preview) destination, and the Current
window will display the Current (program) destination.
2. Select a new destination by
— pressing a category (e.g., “VTR”) and unit number combination, or by
— using the UP and DOWN arrows to scroll through all destinations, or by
— pressing a category key and using UP/DOWN to scroll through available units in that category; or by
— selecting a destination on the CP 3809 Expansion Panel (if so equipped—see Figure 6−122), or by
— selecting a destination on the adjacent CP 3830 dual panel (if so equipped—see below).
3. When the desired destination is displayed in the Preset window, press the TAKE button to select it. The Current window
will return to the input mnemonic; the Preset window will go blank.
On a CP 3830P auto preview panel, press TAKE to change the Current (program) output; or press PRESET TAKE
(CHOP button) to change the Preset (preview) output. The Current window will then show the source feeding the pro-
gram output. The Preset window will show the source feeding the preview output.
Note: if the panel cannot be changed to the desired output, it may have been limited to certain outputs by the
CP Output set used on the MPK Devices table. See page 5−112.
CP 3830 Dual Configuration—Dedicated Output Panel
Dual CP 3830 panels can be configured so that the second panel is used for output selection. The output panel’s buttons will
glow amber. For configuration instructions, see page 5−126.