If power cord(s) WERE NOT supplied with the unit, choose a cord based on the following information:
For units installed in the USA or Canada: Select a flexible,
Any of the following types are acceptable: SV, SVE, SVO, SVT, SVTO,
SVTOO, S, SE, SO, SOO, ST, STO, STOO, SJ, SJE, SJO, SJOO, SJT,
SJTOO,
For units installed in all other countries: Select only a flexible,
Plugging in the Unit
To plug in the unit:
1Plug the power cord into the power source.
2Plug the other end of the cord into the AC inlet located in the topmost section of the CoreBuilder 7000 family ATM switch front panel. Make sure the power cord is fully seated. A green power LED on the power supply should be lit. The unit is automatically powered up when the power cord is plugged in.
3Make sure the fans are working. If the fans are not working, unplug the unit immediately and see “Fans do not rotate” on page