3Com DUA3700-0BAA04 manual Default Parameter Values

6-6CHAPTER 6: CONFIGURING THE COREBUILDER 7000 FAMILY ATM SWITCH

Table 6-1Setup Procedure Sections (continued)

Setup Section		Description
4	FastBUS Configuration	Configure the FastBUS card if installed.
5	Interface Type	Set the interface type port parameters for
		CoreBuilder 7000
6	LE Client Configuration	Define potential vLANs by assigning names to
		ELANs. Exit this section by pressing Enter only.
7	Virtual Network	Assign chassis ports to potential vLANs.
	Configuration
8	Admin VN Management	Set up admin vLAN in all modules including
	Configuration	setting IP address
9	Confirmation	Confirm setup

Entering Data The Integrated Fast Setup procedure runs sequentially through the relevant data for all of the sections, displaying a prompt for each data item and a default value. If you want to change the default, enter the desired value in place of the default. If you want to accept the default, press Enter.

Default Parameter Values

The default parameter value displayed at the prompt is the value stored in flash memory. In case there is no value in flash memory, the factory default value is displayed.

Navigation Aids Table 6-2 lists the short-cut characters you can use to move between

sections of the Integrated Fast Setup procedure:

Table 6-2Integrated Fast Setup Procedure Navigation Aids

Type: To Go:

<Back to previous section

> To next section

>S	To section indicated by double-underlined identifier letter S in section
	title

\Back to beginning of setup

$ To end of setup

Integrated Fast Setup You initiate the Integrated Fast Setup from the LMA Main Menu of the Operation Corebuilder 7000 family ATM switch (see Figure 6-1).