| entièrement l'unité de toute alimentation, débrancher tous les câbles |
| d'alimentation. |
|
|
Preparation | Before beginning the installation procedures in this chapter, ensure that |
| the CoreBuilder 7000 family ATM switch is placed close to the location |
| where it will be installed and that the mounting brackets and hardware |
| kit supplied with the system are readily available. You will also need a No. |
| 2 Phillips screwdriver. |
| The hardware kit contains: |
| 1 pair of mounting brackets (for distribution rack installation) |
| 10 screws, M4 x 8 Phillips (for mounting brackets) |
| 4 rubber feet (for table installation) |
| 4 screws, M4 x 8 Phillips (for rubber feet) |
|
|
Table Top | The CoreBuilder 7000 family ATM switch is ready for table top installation |
Installation | as shipped. |
| To provide a firmer base for the unit, you can choose to attach four |
| rubber feet to the switch chassis. Use the rubber feet and the four M4 x 8 |
| Phillips screws included in the hardware kit. |
| To insert the power supply, switching modules, and interface cards, |
| configure optical ports for the interface modules and connect network |
| cabling and power to the unit see Chapter 4. |
|
|
Distribution Rack | You can mount the CoreBuilder 7000 family ATM switch in a |
Installation | distribution rack. This section describes how to prepare the unit and the |
| distribution rack, and mount the unit in the distribution rack. Please read |
| all of the instructions carefully before beginning the installation. |
| For the basic mechanical and space requirements for the distribution rack |
| “Distribution Rack Requirements” on page |