3Com DUA3700-0BAA04 manual Perform the LMA menu command

Storing and Retrieving Configuration Parameters 6-25

read from the flash memory. The CoreBuilder 7000 assumes that the user wants to reboot the switch as soon as possible to activate the new configuration parameters. Therefore, subsequent to a configuration download, all LMA and SNMP set operations are blocked until the next reboot – except for the configuration upload/download and reboot operations.

It is recommended, therefore, to perform a configuration download only when you are ready to reboot and activate the new parameters.

Cards should not be “hot swapped” after a configuration download until after the next reboot.

Uploading the To store (upload) the configuration of a card installed in the CoreBuilder Configuration of a chassis from flash memory to disk, first make sure that the switch is

Card connected to the TFTP server and that it is in single-IP mode and then perform the following steps:

1Perform the LMA menu command:

(1)SYS\ (3) LOA \(6) TCU

2The LMA automatically presents you with a list of the installed cards whose configuration you can upload to disk, for example:

Module Types:
1<Switch	module 7000>
2<Slot 3	- 7600>
3<Slot 4	- 7600>
4<Slot 5	- 7400>
5<Slot 6	- 7200>

Select Module: 1

Select the appropriate card from the list—for example, if you want to upload the configuration of the active switch card, select 1 from the menu.

3The types of configuration data you can upload are displayed as follows.

File Types: 1<All>

2<Box Profile> 3<ATM Addresses> 4<PNNI Configuration> 5<LANE Security> 6<PVC Connections> 7<LECS Topology> 8<LECS Order List>