9<Other>
Select File type:
Enter the number of the type of configuration parameters you want to upload. For example, if you want to upload all configuration parameters, select File type 1.
4Enter the IP address of the TFTP server:
Server IP address: 100.0.0.111
5Enter the name of the file to receive the data on disk:
Name of file to be uploaded: 7000_cfg
Enter a file name without an extension. For the “All” option, the system adds sequential extensions.
6Confirm the upload.
Start upload to 100.0.0.111, file name 7000_cfg, (Y/N)? y
The following messages are displayed for each data type:
Loading, file name switch/cfg/24_7_cfg.1, file type Box
Profile
Load process of file type Box Profile completed successfully
7Verify the success status of the upload by the LMA menu item:
(1)SYS:\ (3) LOA: \(1) STS
The upload status is displayed as follows:
Load process completed successfully.
The status will be “success” only if all the files were successfully loaded. In case of failure to load a file, the “load all” process will be stopped without continuing to the next file, a failure indication is displayed, and the display status option displays the error message:
General Error occurred while loading
Loading a Single Configuration Data Type
If you want to upload a single data type instead of the entire configuration, proceed as follows from step 3
3Select File type: 2
4Server IP address: 100.0.0.111
5Name of file to be uploaded: switch/cfg/box_prof.cfg
For loading a single item you can enter a full file name.