Loading NetWare ODI Drivers 4-13
6Repeat steps 3 and 4 for each adapter.
7Exit the program.
NetWare Driver Installation
To install the 4.x server driver, follow these steps:
1Copy the contents of the appropriate \NETWARE subdirectory to the boot partition of the server‘s hard disk.
2When you start the server, enter the following commands:
For NetWare 3.11:
load C:LSLENH.NLM [Enter]
load C:3C59X.LAN PORT=XXXX NAME=X [Enter] load C:3C59X.LAN PORT=XXXX NAME=Y [Enter] bind ipx to X net=XXXX [Enter]
bind ipx to Y net=XXXX [Enter]
For NetWare 3.12, 4.0, or 4.0x:
load C:3C59X.LAN PORT=XXXX NAME=X [Enter] load C:3C59X.LAN PORT=XXXX NAME=Y [Enter] bind ipx to X net=XXXX [Enter]
bind ipx to Y net=XXXX [Enter]
where XXXX is the adapter’s port address. (To determine the port address, refer to the previous section, “Finding the Adapter’s Port Address for Multiple Adapters.”) The NAME=X and NAME=Y parameters that you assign help distinguish the multiple adapters.
If the load sequence is not followed, the system will not operate correctly. Make sure that the PORT XXXX parameter is entered for all adapters.
When running the 3C59X.LAN driver with NetWare 3.11, you must update the MONITOR.NLM file that accompanied NetWare 3.11 with the MONITOR.NLM file from Novell.
For the latest NLMs, contact Novell.
This concludes the procedure for installing multiple adapters in an EISA computer functioning as a server.
