Reference — Hardware installation
3.Slide the RFID pad into the clips as shown.
4.Fasten the fourth clip with the included screw.
Connect RFID reader communication and power cables
WARNING
To reduce the risks associated with hazardous voltage contained within the power supply, which, if not avoided, could result in death or serious injury:
•Do not use the power supply if the case or cord are damaged.
•Do not use the power supply in outdoor or wet environments.
•Do not attempt to service or repair the RFID circuitry or power supply — no user serviceable parts inside.
•Do NOT alter system power cords, e.g., by replacing power cord plugs to work with local electrical outlets. Purchase power cords locally when factory cords do not work in a particular location.
Note: The RFID pad must be connected to the RFID reader before applying power to the system.
Note: When everything is hooked up and the power is on, the RFID reader Power light should be flashing Green and the Communication light should be flashing Red. If the lights are off, see Troubleshooting in this manual.
Cable lengths — RFID reader and RFID pad
•Coaxial cable — RFID pad to RFID reader, 6.67 ft. (2 m)
•USB cable — RFID reader to computer, 6.67 ft. (2 m)
•Power supply cable — RFID reader to power transformer, 6.67 ft. (2 m)
•AC power cord — Power transformer to AC power, 9.8 ft. (3 m)
Copyright © 2009, 3M. All rights reserved. | 27 |
