3M 813 owner manual Regulatory compliance, FCC compliance statement regular volume printer

Regulatory compliance

FCC compliance statement — regular volume printer

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that the interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference

by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and the receiver.

•Connect the equipment into an outlet on a circuit different than that to which the receiver is connected.

•Consult the dealer or an experienced Radio/TV technician for help.

Note: This unit was tested with shielded communication cables on the peripheral devices. Shielded communication cables must be used with the unit to ensure compliance.

FCC compliance statement — high volume printer

This device complies with Part 15 rules. Operation is subject to the following two conditions:

1.This device may not cause harmful interference, and

2.This device must accept any interference received, including interference that may cause undesired operation.

The user is cautioned that any changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment. To ensure compliance, this printer must be used with shielded communication cables.

FCC radiation exposure statement (for printers with RFID encoders)

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20 cm between the radiator and your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Canadian DOC compliance statement

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numerique de la classe B est conforme a la norme NMB-003 du Canada.

Copyright © 2009, 3M. All rights reserved. 5