Front-Panel Controls 2
6000 Series Oscilloscope User’s Guide 63
Front and Rear Panel Controls and Connectors
1. Power Switch Press once to switch power on; press again to
switch power off. See page 33.
2. Power Indicator Illuminates green when power is on.
3. LAN Status Indicator This indicator illuminates green when a
LAN connection has been detected and is connected as
configured. The LAN status indicator illuminates red when the
following LA N faults occ ur:
•failure to acquire a valid IP address
•detection of a duplicate IP address
•failure to renew an already acquired DHCP lease
The LAN status indicator flashes green when the identify
function is activated (see page 49).
4. Reset Switch When power is on, press and release this
recessed pushbutton to default LAN parameters. See page 40.
5. Intensity Control Rotate clockwise to increase analog
waveform intensity; counterclockwise to decrease. You can vary
the intensity control to bring out signal detail, much like an
analog oscilloscope. Digital channel waveform intensity is not
adjustable. More details about using the Intensity control to
view signal detail are on page 263.
6. USB Host Port Connect a USB compliant mass storage device
to store or recall oscilloscope setup files or waveforms. You can
also use the USB port to update the oscilloscope’s system
software or Quick Help language files if updates are available.
You do not need to take special precautions before removing the
USB mass storage device from the oscilloscope (you do not need
to “eject” it). Simply unplug the USB mass storage device from
the oscilloscope when the file operation is complete. More
information on using the USB port is given in Chapter 7, “Saving
and Printing Data,” starting on page 315.