| Remote operation |
|
|
| HSCSD Subsystem GPIB Commands | ||
| HSCSd:SLAVe:UPLink:AMPLitude | ||
Description | This sets the expected input level of the slave timeslot. | ||
| In standard mode, this sets the slave’s uplink amplitude control to | ||
| MANUAL. In compatibility mode, if the slave’s uplink amplitude control is | ||
| set to MS TX LEV then an error occurs and the setting is not performed. If | ||
| the measurement timeslot (see page 43) is set to Slave, the analyser | ||
| level of the unit is set to this value. | ||
Syntax | HSCSd:SLAVe:UPLink:AMPLitude? | ||
| HSCSd:SLAVe:UPLink:AMPLitude <real> <units> | ||
Command options |
|
|
|
|
|
|
|
| Type | float |
|
|
|
|
|
| Units: | dBm only |
|
|
|
|
|
| Limits (GSM900): |
| |
|
|
|
|
| Limits |
| |
|
|
|
|
| Limits (DCS1800): |
| |
|
|
|
|
| Limits (PCS1900): |
| |
|
|
|
|
| Default (compatibility mode): | 33.0 |
|
|
|
|
|
| Default (GSM900) | 13.0 |
|
|
|
|
|
| Default | 13.0 |
|
|
|
|
|
| Default (DCS1800): | 10.0 |
|
|
|
|
|
| Default (PCS1900): | 10.0 |
|
|
|
|
|
60 | Chapter 5 |
