Agilent Technologies Agilent 86120C manual Combine commands from different subsystems, White space

Programming

Reviewing SCPI Syntax Rules

Combine commands from different subsystems

You can send commands and program queries from different sub- systems on the same line. Simply precede the new subsystem by a semicolon followed by a colon. In the following example, the colon and semicolon pair before DISP allows you to send a command from another subsystem.

OUTPUT 720;”:CALC2:PEXC 12;:DISP:WIND:GRAP:STAT OFF”

Sending common commands

If a subsystem has been selected and a common command is received by the instrument, the instrument remains in the selected subsystem. For example, if the program message

”DISPLAY:MARK:MAX:LEFT;*CLS;DISP:MARK:MAX:RIGH”

is received by the instrument, the Display subsystem remains selected.

If some other type of command is received within a program message, you must reenter the original subsystem after the command.

Adding parameters to a command

Many commands have parameters that specify an option. Use a space character to separate the parameter from the command as shown in the following line:

OUTPUT 720;”:INIT:CONT ON”

Separate multiple parameters with a comma (,). Spaces can be added around the commas to improve readability.

OUTPUT 720;”:MEAS:SCAL:POW:FREQ? 1300, MAX”

White space

White space is defined to be one or more characters from the ASCII set of 0 through 32 decimal, excluding 10 (NL). White space is usually optional, and can be used to increase the readability of a program.

Numbers

All numbers are expected to be strings of ASCII characters. Thus, when sending the number 9, you would send a byte representing the ASCII code for the character “9” (which is 57). A three- digit number like 102 would take up three bytes (ASCII codes 49, 48, and 50). This

3-25