Agilent Technologies N8201A manual To install the instrument in a rack

Preventive Maintenance 5

Half-Rack-Width Instrument

To install the instrument in a rack

Step Note

1Make sure the system is powered off.

2	Insert the attached instruments in the same	• The rack-mount ears stop the instruments at
	slot from which you removed them, sliding	the correct depth.
	them along the support rails until they meet
	the rack-mount ears.
3	Replace the rack panel in front of the	• The screws are located near the corners of
	instruments and secure the four corner	the face of the instrument.
	screws.	• Use a #2 Phillips screwdriver.

4Confirm that the instrument is turned off.

5Connect the appropriate cables to the instruments (front and rear), including the power cords.

6 Power on the system. .

Bench Top Instrument

To install an instrument in a bench top system

1Make sure the system is powered off.

2Connect all cables to the instrument (front and rear), including the power cord.

3Connect the power cord to the AC power source.

4Power on the system.

5Set the instrument GPIB address, if necessary.

Agilent N8201A Performance Downconverter Synthetic Instrument Module, 3 Hz to 26.5 GHz 101