Agilent Technologies N8201A Equipment Installation, Acoustic Noise Emission/Geraeuschemission

Service, Support, and Safety Information 6

Acoustic Noise Emission/Geraeuschemission

LpA <70 dB	LpA <70 dB
Operator position	am Arbeitsplatz
Normal position	normaler Betrieb
per ISO 7779	nach DIN 45635 t.19

All light-emitting diodes (LEDs) used in this product are Class 1 LEDs per IEC 60825-1.

Equipment Installation

Install the instrument or system so that the detachable power cord is readily identifiable and is easily reached by the operator. The detachable power cord is the disconnecting device. It disconnects the mains circuits from the mains supply before other parts of the instrument or system. The instrument front panel switch is only a standby switch and is not a LINE switch. Alternatively, an externally installed switch or circuit breaker (which is readily identifiable and is easily reached by the operator) may be used as a disconnecting device.

WARNING	This is a Safety Class 1 Product (provided with a protective earthing ground
	incorporated in the power cord). The mains plug shall be inserted only in a socket
	outlet provided with a protective earth contact. Any interruption of the protective
	conductor inside or outside of the product is likely to make the product
	dangerous. Intentional interruption is prohibited (IEC 348 clauses 17.3.3 c and
	17.3.4).
	DO NOT OPERATE IN AN EXPLOSIVE ATMOSPHERE.
WARNING
	Do not operate the instrument or system in the presence of flammable gases or
	flames.
	Danger of explosion if battery is incorrectly replaced. Replace only with the same
WARNING
	or equivalent type recommended. Discard used batteries according to
	manufacturer’s instructions.

Agilent N8201A Performance Downconverter Synthetic Instrument Module, 3 Hz to 26.5 GHz 105