WARNING
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE.
Miiiiiu
“CAUTION TO REDUCE THE RISK OF
ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL “
Explanation of Graphical Symbols:
The lightning flash with arrowhead symbol, A within an equilateral triangle, is intended to
alert the user to the presence of uninsulated “dangerous voltage” within the product’s en- closure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and mainte- nance (servicing) instructions in the literature
A ●accompanying the appliance.
PRECAUTIONS
Read the Operating Instructions carefully and completely before operating the unit. Be sure to keep the Operating Instructions for
future reference. All warnings and cautions in the Operating Instructions and on the unit should be strictly followed, as well as the safety suggestions below.
Installation
1Water and moisture – Do not use this unit near water, such as near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, swimming pool, or the like.
2Heat – Do not use this unit near sources of heat, including heating vents, stoves, or other appliances that generate heat. It also should not be placed in temperatures less than 5°C (41 ‘F) or greater than 35-C (95”F).
3Mounting surface – Place the unit on a flat, even surface.
4Ventilation – The unit should be situated with adequate space around itsothat proper heatventilation is assured. Allow 10cm (4 in.) clearance from the rear and the top of the unit, and 5 cm (2 in.) from the each side,
-Do not place the unit on a bed, rug, orsimilarsurface that may block the ventilation openings.
-Do not install the unit in a bookcase, cabinet, or airtight rack where ventilation may be impeded.
5Objects and liquid entry – Take care that objects or liquids do not get inside the unit through the ventilation openings.
6Carts and stands – When placed or mounted on a stand or cart, the unit should be moved with care.
Quick | stops, excessive force, and un- | ●L |
even surfaces may cause the unit or | m AL* 3 |
cart to | overturn or fall. |
7Condensation – Moisture may form on the CD pickup lens when:
-The unit is moved from a cold spot to a warm spot
-The heating system has just been turned on
-The unit is used in a very humid room
-The unit is cooled by an air conditioner
When this unit has condensation inside, it may not function normally. Should this occur, leave the unit for a few hours, then try to operate again.
8Wall orceilina mountina– The unit should not be mounted on a wall or ceilin~, unless s~ecified in the Operating Instructions.
Electric Power
1 Power sources – Connect this unit only to power sources specified in the Operating Instructions, and as marked on the unit.
2Polarization – As a safety feature, some units are equipped with polarized AC power plugs which can only be inserted one
way into a power outlet. If it is difficult orimpossibleto insert the AC power plug into an outlet, turn the plug over and try again. If it still does not easily inserf into the outlet, please call a qualified service technician to service or replace the outlet. To avoid defeating the safety feature of the polarized plug, do not force it into a power outlet,
3AC power cord
-When disconnecting the AC power cord, pull it out by the AC power plug. Do not pull the cord itself.
-Never handle the AC power plug with wet hands, asthiscould result in fire or shock.
-Power cords should be routed to avoid being severely bent, pinched, or walked upon. Pay particular attention to the cord from the unit to the power socket.
-Avoid overloading AC power plugs and extension cords beyond their capacity, as this could result in fire or shock.
4Extension cord – To help prevent electric shock, do not use a polarized AC power plug with an extension cord, receptacle, or other outlet unless the polarized plug can be completely in- serted to prevent exposure of the blades of the plug.
5When not in use – Un~lug the AC Dower cord from the AC outlet if the unit will not “be-used for several months or more. When the cord is plugged in, a small amount of current continues to flow to the unit, even when the power is turned off.
Maintenance
Clean the unit only as recommended in the Operating Instructions.
Damage Rectuirinc! Service
Have the unit serviced by a qualified service technician if:
-The AC power cord or plug has been damaged
-Foreign objects or liquid have gotten inside the unit
-The unit has been exposed to rain or water
-The unit does not seem to operate normally
-The unit exhibits a marked change in performance
-The unit has been dropped, or the cabinet has been damaged
DO NOT ATTEMPT TO SERVICE THE UNIT YOURSELF.
Owner’s record
For your convenience, record the model number and serial number (you will find them on the rear of your set) in the space provided below, Please refer to them when you contact your Aiwa dealer in case of difficulty.
Model No. | Serial No. (Lot No.) |
CSD-MD50
