Aiwa CSD-MD50 manual Troubleshooting Guide, An erroneous display or a malfunction occurs, To reset

TROUBLESHOOTING GUIDE

If the unit fails to perform as described in these Operating Instructions, check the following guide.

GENERAL

There is no sound.

●Is the AC cord connected properly?

An erroneous display or a malfunction occurs.

+Reset the unit as stated below.

TUNER SECTION

There is constant, wave-like static.

●Is the antenna connected properly? (~ page 4)

The reception contains noise interferences or the sound is distorted.

●Is the system picking up external noise or multipath distortion?

+Change the orientation of the antenna.

+Move the unit away from other electrical appliances.

CASSETTE DECK SECTION

The tape does not run.

●Is the deck in pause mode? (-+ page 13)

The sound is off-balance or not adequately high.

QIs the playback head dirty? (+ page 28)

Recording is not possible.

●Is the erasure prevention tab on the tape broken off? (+ page 13)

*Is the recording head dirty? (+ page 28)

Erasure is not possible.

●Is the erasure head dirty? (+ page 28)

●1s a metal or CrOz tape being used? High frequency sound is not emitted.

●Is the recording/playback head dirty? (+ page 28)

CD PLAYER SECTION

The CD player does not play.

●Is the disc correctly inserted? (~ page 11)

●Is the disc dirty? (+ page 28)

●Is the lens affected by condensation?

+ Wait approximately one hour and try again

To reset

If an unusual condition occurs in the display window, reset the unit.

Press the reset button on the rear of the unit with a small screw driver or a similar tool.

Everything stored in memory after purchase is canceled.

MD RECORDER SECTION

The MD recorder cannot be operated

●Is there a disc inside the unit ?

.+ Insert a disc.

●Is the lens affected by condensation?

.+ Wait approximately one hour and try again.

Sound is noisy

●Is the unit placed close to an object with a strong magnetic field such as a television?

.+ Move the unit away from the television.

Sound is intermittent

●Is the unit placed on an unstable surface with a lot of vibration? -+ Place the unit on a stable surface with no vibration.

Recording is not possible

●Is the CD E MD button pressed when attempting to record from the radio?

-+ Press the ● MD REC button to record from the radio.

●Is a prerecorded disc inserted?

-+ Change to a recordable disc.

●Is the disc protected by the record-protected tab on the disc? (+ page 18)

ENGL/SH 3I