Overview

Unpacking the Unit

Your system was shipped in one box and contains the 1:15 Blu-ray/DVD/CD Tower Publisher SLS and cables.

Carefully open the box and remove the top protective foam padding. Remove the following:

1:15 Blu-ray/DVD/CD Tower Publisher SLS2 Power Cords1 USB 2.0 Cable1 Quick Start Guide1 Installation CD

Note: It is important to keep the original shipping container and packaging. In the event you misplace your packaging and need to ship the 1:15 Blu-ray/ DVD/CD Tower Publisher SLS, you should first contact technical support to purchase a new shipping container. Shipping the 1:15 Blu-ray/DVD/CD Tower Publisher SLS without proper packaging will void your warranty.

Connect the Cables and Apply Power

Plug the 2 power cords into the power supply of the 1:15 Blu-ray/DVD/CD Tower Publisher SLS, also located on the rear side (make sure the red switch is set at 115 VAC for US operation). Plug into a standard 115 VAC outlet.

Plug the USB 2.0 Cable into the USB connector located on the center rear of the 1:15 Blu-ray/DVD/CD Tower Publisher SLS. Connect the other end of the USB cable into an available USB 2.0 port on your PC.

Note: Use only with a USB 2.0 port. This system cannot be used with USB 1.1, as this will greatly affect system performance. If Windows displays a message that a fast USB device is detected on a slow USB port, then you will need to upgrade your computer by adding a USB 2.0 port.

www.aleratec.com

7