The following steps will show you how to load your Master Disc into the installed Hard Drive as a partition and copy the stored partition onto blank discs. This process is recommended for mass volume production.
To load your Master Disc onto a hard drive partition, please do the following:
1.Make sure the Source is set to the Hard Drive.
It is very important to make sure the Source is set for the Hard Drive in order to avoid unnecessary error messages. To check what the Source is set to, please do the following:
a. Use UP or DOWN arrow button to navigate to the following screen.
Aleratec | 1.00 |
9. Select Source |
|
COPY USB PRINT | SOURCE |
ESC ENT
b.Press ENT to enter “Select Source” menu and you will see the following:
Hard Drive Port 1.0 | |
XXXXXX | ESC ENT |
COPY USB PRINT SOURCE | |
Make sure it is located at “Hard Drive”. If not, press the UP or DOWN arrow button to search for it. There will be drive model information where
XXXXXX is shown above.
c.Press ENT to submit your selection. After your selection has been submitted, you will see the following display:
Aleratec | 1.00 |
9. Select Source |
|
COPY USB PRINT | SOURCE |
ESC ENT
2.Load your Master Disc onto the Hard Drive.
a. Use the UP or DOWN arrow button to navigate to the following screen.
Aleratec | 1.00 |
11. Hard Drive Setup |
|
COPY USB PRINT | SOURCE |
ESC ENT
24www.aleratec.com