Disadvantage:
▪▪The loading time may have an impact on overall duplication time for small duplication jobs.
▪▪The Master Disc will be loaded to the reserve partition in the Hard Drive temporarily until a new master is loaded and overrides the previous image. In comparing this duplication mode with the traditional “Duplication from Hard Drive” process, it offers the user more simplicity. By selecting the “Load and Copy” mode via one simple touch, all the necessary tasks will be automated for you and loaded on to the “Reserved” partition. You can rename the data on the “Reserved” partition and place it in a standard partition if you wish to keep it. (This must be done prior to loading a new master through “Load and Copy)”.
By default, the duplication mode is set to “Auto”. This will prompt you to choose between one of the duplication modes when you enter any of the following functions: “Copy”, “Test”, “Test + Copy”, and “Copy + Compare”.
However, if you prefer not to be prompted each time, you can always go to “14. Setup” and select
1.Turn on the duplicator. After the bootup is complete, you will see the following display:
Aleratec | 1.00 |
1. COPY |
|
COPY USB | PRINT SOURCE |
ESC ENT
2.Press the UP or DOWN button consecutively until you see following display:
Aleratec | 1.00 |
14. Setup |
|
COPY USB | PRINT SOURCE |
ESC ENT
3.Press ENT button once. You will see the following display:
Setup | |
1. Language | ESC ENT |
COPY USB PRINT SOURCE | |
4. Press the UP or DOWN button consecutively until you see following display:
Setup
9. Duplication Mode
COPY USB PRINT SOURCE
ESC ENT
www.aleratec.com55