Alti-IP 600 Manual 27
Formore detailed information regardingNAT configuration guidelines and
implementation, refer to the AltiWare OE/ACC or ACM System
Administration Manual.
Note: If more than one Alti-IP 600 phone sit sb ehind NAT, a VPN tunnel
isrequired to connect between the NAT router and the corporate
router.
Assigning NAT
By default, NAT is not enabled. If you connect the Alti-IP 600 behind a
NATrouter, you may manually assign the NAT router’s public IP address
tot his field.
Toassign the NAT address, use the following steps:
1. Press **7+ENTER button.
2. Use !/"to select Network,thenpresstheENTER button.
3. Scroll to Enable NAT.
4. Press "(DOWN key) to select YES.
5. Press the ENTER button.
6. Use $(BACK key) to return to the Network menu, then select NAT
Address.
Usethe buttons on the dial pad to enter the new NAT address, using
the* key to enter periods. Use $(BACK key) to correct any mistakes.
7. Press the ENTER button.
Setting Ring Tones
TheAlti-IP 600 Phone has three (3) ringing tones available. To set the ring
tone:
1. Press **6ENTER.
2. Scroll to SELECT RING andpress ENTER or #(FORWARD key).
3. Scroll to desired ring tone (0-2), or press 0,1or 2on the dialing pad,
thenpress ENTER.