θ4. Press the “Escape” key on the display until the top level menu screen appears. Select “Status.” Pressing the enter key opens the voltage status screen as illustrated below.
Note: The fault light on the display may remain on. Disregard this visual indicator at this time.
θ5. Record input voltages below, and compare with measured voltages from step 1. If the two measurements are significantly different, contact APC SymmetraTM technical support.
Vin1: ______________________
Vin2: ______________________
Vin3: ______________________
θ6. Switch the maintenance bypass switch on.
Note: Disregard any LED indicator or fault messages on the PowerView.
Record output voltage below, and compare with Vin1 from step 5. If the two measurements are significantly different, contact APC SymmetraTM technical support.
Reported Output Voltage: Out:____________V_________Hz
θ7. Test the EPO switch. The system enable switch should physically move to the “stand by” position, and the system should shut down completely. If this does not occur, check the connections and the EPO switch to ensure they are installed and functioning properly.
θ8. Successful completion of steps 1 through 7 indicate that the system wiring is properly installed. Turn off breakers and switches and shut down input power to the system. Reinstall all wiring access panels on the frame.
Electrical Installation Completed by: __________________________________________
__________________________________________
__________________________________________
Electrical Installation - Page 11 | |
|
