American Power Conversion SYMSTRF3I user manual Startup Screen, Top-Level Menu Screen

The Startup Screen

The factory default startup screen is opened by pressing the escape key. It displays the following information:

νFuel Percentage - the percentage of battery capacity (fuel) that is presently available.

νLoad Percentage - the percentage of system capacity that is being used to supply conditioned power to the load equipment.

νVoltage and Frequency - the input/output voltage, and the ouput frequency.

νRun Time - the run time that can be expected, based on the amount of power required by the load equipment, and the power capacity of all battery modules connected to the SymmetraTM Power Array.

Note: The PowerView interface will “time out” after ten minutes of inactivity, and the LCD display will go blank. The screen display will reappear when any key is touched.

Note: The startup screen for the international single phase models is depicted. Your startup screen may vary.

Top-Level Menu Screen

Press the escape key to open the “Top-Level Menu” screen. This screen is the “launching pad” to monitor, com- mand and configure the system. Refer to the following tables for all PowerView commands and controls. Note: The selection arrow in the illustration below is used to select a command. Pressing the up or down key moves the selection arrow to the desired command, and then pressing the enter key opens it.

Page 4 - The PowerView Interface - Appendix A 990-7169-001