MVP-WDS Wall Docking Station & CB-MVPWDS Conduit Box
1
MVP-WDS Wall Docking Station for MVP Panels
MVP-WDS Wall Docking Station & CB-MVPWDS Conduit Box

Overview

The MVP-WDS Wall/Flush Mount Docking Station (FIG.1) provides a surface-installed docking
location. MVP-WDS stations use a security latch to secure the panel to the docking station for MVP
panels, and come in 2 faceplate colors; black (FG5965-11) and silver (FG5965-21).
The Security Release pushbutton raises the security latch for easy removal of the MVP panel.
The securing magnet is used to keep the MVP panel from falling out of the cradle when the
MVP is angled forward.
One or two (optional) MVP-BP batteries can be recharged from either of the two rear
compartments on the MVP-WDS (or from within the MVP panel).
Attach a keyboard or mouse using the docking station's side USB ports. This connection
facilitates surfing the Web via the G4 Computer Control application.
Another key feature of the MVP-WDS is that it can be mounted into either a solid surface
(using surface screws) or into an optional CB-MVPWDS conduit box (for pre-wall
installation). These two installation options allow the MVP to be mounted into virtually any
surface environment. Refer to the Installationsection on page 4 for more information.
FIG. 1 MVP-WDS Docking Station components
Security
MVP-BP battery
Interface Connector pins
Securing
alignment guide pin
Security Release pushbutton
latch
support cradle
compartment
magnet
(with 2 blue status LEDs)
Power
Die Cut Foam
plastic covers (2)
USB (2)
alignment guide pin
The faceplate must be removed prior to any installation of the WDS into a surface or
CB-MVPWDS conduit box. The two Die Cut Foam covers are then placed over the
two #6-32 faceplate security screws, post installation.
A security code (password) can be enabled via the Protected Password page. This
feature requires that the code must be entered on the panel before it can be removed
from the docking station.