Faceplate Securing Latches Faceplate Connectors | AMX MVP-WDS

MVP-WDS Wall Docking Station & CB-MVPWDS Conduit Box

Faceplate Securing Latches

Faceplate Connectors

FIG. 7 Faceplate securing latch and connector locations

8.Press down on the Security Latch to allow it to go through the top opening.

9.Grasp the top rim of the faceplate and carefully slide it over the cradle (at an angle) until the faceplate is completely removed from the WDS (FIG. 8).

Faceplate securing latches

Faceplate

FIG. 8 Faceplate removal from MVP-WDS

Once the faceplate has been removed, you can continue the installation of the WDS.

MVP-WDS Wall Docking Station for MVP Panels	7

Image 13

AMX MVP-WDS manual Faceplate Securing Latches Faceplate Connectors

Contents

MVP-WDS AMX Limited Warranty and Disclaimer FCC Information Page Table of Contents Page Overview MVP-WDS Wall Docking Station & CB-MVPWDS Conduit Box MVP-WDS Specifications Specifications LED Indicators MVP-WDS docking station connector locations Installing the CB-MVPWDS Conduit Box Installation MVP Support Cradle Removing the MVP-WDS Faceplate Security Latch Faceplate Securing Latches Faceplate Connectors Installing the MVP-WDS in a CB-MVPWDS Conduit Box Installing the MVP-WDS Using Expansion Clips MVP-WDS Wall Mount cutout dimensions using expansion clips Replacement drywall clip sets cab be ordered from AMX Screws not included Powering the MVP-WDS Connecting a Power SupplyReplacing the Faceplate on the MVP-WDS Connecting and Using USB Input Devices on the Stations Using the 3.5mm mini-Phoenix Connector for Power Securing an MVP Panel to an MVP-WDS Interface Connector Pins and Functions Unsecured MVP removal from an MVP-WDS Removing an MVP Panel from an MVP-WDSSecured MVP removal from an MVP-WDS Installing MVP-BP Batteries Into the MVP-WDS Installing and Charging Batteries in the Docking StationsUndock-USER String Removing the original faceplate Installing the MVP-WDS-SK Silver Conversion Kit Security Latch Faceplate securing latches Gap opening Removing the attached circuit boards a & B Installing the new conversion kit’s pivot unit components Installation of silver cradle pivot and battery cover Installing the new silver faceplate MVP-WDS Wall Docking Station & CB-MVPWDS Conduit Box Prepare the Docking Station for firmware transfer via USB Upgrading the Docking Station Firmware Default Modero panel value is Upgrade the Docking Station firmware via USB Device and System values Upgrading the Docking Station Firmware Page It’s Your World Take Control