![](/images/new-backgrounds/1264143/2641437x1.webp)
Characteristics
Characteristics common to all cubicles
◗After moving them to their installation location on their pallets,
MGETM GalaxyTM 6000 cubicles can be moved short distances using a forklift or
+/– 10 mm high openings;
◗the unadjusted cubicle height (H) is 1900/2000 mm; after lifting the cubicle, the height can be adjusted +/– 10 mm by screwing in or out the four feet;
◗the bearing surface corresponds to the area of the four cylindrical foot pads (60 mm diameter) positioned in each corner of the cubicle;
◗the cubicle depth (D) is 840 mm (800 mm without doors and panels);
◗operating temperature range for
8 hours) and 30°C maximum for overload conditions. Operation outside the specified temperature range will reduce service life;
◗relative humidity: 95% maximum;
◗maximum operating altitude without derating: 1000 m;
◗connection via the bottom for
◗the connection cables may be run in three ways:
◗in a trench running under the cubicles,
MGETM GalaxyTM 6000 UPS: example of a
H |
L |
P |
◗under a false floor,
◗on the floor under the cubicles, in the free space equal to the height of the feet; in this case the cables should be run side by side to avoid blocking the flow of air for ventilation.
◗the intercubicle connection cables are not supplied (except for the wires for auxiliary interconnections);
◗normally the cubicles do not have to be secured to the floor; the footpads nevertheless have holes with an average depth of 12 mm designed for the fitting of M16 anchor bolts;
◗the cubicle doors are secured by Ronis locks (key 405).
Page 4 - 6739381EN/JD