APC UPS control system manual Apcaccess eprom

LOADPCT	: 11.4	Percent Load Capacity
BATTV	: 27.7 Volts
BCHARGE	: 100.0	Percent
MBATTCHG : 5 Percent
TIMELEFT : 112.0		Minutes
MINTIMEL : 3 Minutes
SENSE	: Low
DWAKE	: 060 Seconds
DSHUTD	: 180 Seconds
LOTRANS	: 204.0	Volts
HITRANS	: 253.0	Volts
RETPCT	: 050.0	Percent
STATFLAG : 0x08 Status Flag
STATUS	: ONLINE
ITEMP	: 29.2 C Internal

ALARMDEL : Low Battery

LASTXFER : U command or Self Test

SELFTEST : NO

STESTI	: 336
DLOWBATT : 02 Minutes
DIPSW	: 0x00 Dip Switch
REG1	: 0x00 Register 1
REG2	: 0x00 Register 2
REG3	: 0x00 Register 3
MANDATE	: 01/05/99
SERIALNO : GS9902009459
BATTDATE : 01/05/99
NOMOUTV	: 230.0
NOMBATTV : 24.0
HUMIDITY : N/A
AMBTEMP	: N/A

EXTBATTS : 0

BADBATTS : N/A

FIRMWARE : 60.11.I

APCMODEL : IWI

END APC : Fri Dec 03 12:34:33 CET 1999

For the various smaller, cheaper APC USB UPSes, such as the CS, ES, ..., you will get much of the information that is presented above, but not all of it. For example, you will not get MAXLINEV, MINLINEV, LINEFREQ,

... and in particular, the LOADPCT will be zero when you are running on mains. LOADPCT will display when the UPS is on batteries. You must remember that the non-SmartUPSes are much simpler (and less expensive) and therefore produce less information.

apcaccess eprom:

The eprom command line option for apcaccess allows you to examine the current values of your UPS’ EPROM as well as to know the permit-

74