Apple 4400, 7300 manual 117

20Route the second cable over the top of the PC Compatibility Card, behind the processor card, around the back of the logic board, and through the hole in the computer’s chassis.

Be sure to route the cable between the processor card and the back panel (not over the top of the processor card).

Keep the cable away from the heat sink and the center support post. You’ll connect this cable to the CD-ROM drive in step 26.

Route the cable around the back of the computer’s interior as shown.

Feed the other end of the cable a few inches into this hole in the computer chassis.

Processor card Support post

IMPORTANT If you are installing the PC Serial and Parallel Card, you should insert it now. See the PC Serial and Parallel Card manual for instructions.

Reinstalling the PC Compatibility Card in Your Power Macintosh 7300 Computer 117