Apple 4400 Removing the card, Installing the port access cover, Installing the audio ribbon cable

Removing the card

3Grasp the card by its edges (without touching any components on the card) and pull it straight out of the slot.

IMPORTANT Do not rock the card side to side as you remove it. Doing so may break the card or damage the slot.

Installing the port access cover

4Slide the port access cover into the port access opening at the back of the computer, to cover the opening.

Use the port access cover that came with your computer (shown earlier in this appendix).

Installing the audio ribbon cable

5Plug the audio ribbon cable into your CD-ROM drive and into the CD Audio connector on the Macintosh logic board.

You need the audio ribbon cable that came with your computer (shown earlier in this appendix). Plug either end of the cable into your CD-ROM drive, thread it through the slot in the chassis, and plug the other end into the CD audio connector on the Macintosh logic board (where you unplugged one of the audio cables in step 1).

Replacing the computer’s cover

Replace the computer’s cover by following the instructions in Appendix B, in the section “Replacing the Computer’s Cover.”

Removing the PC Compatibility Card From Your Power Macintosh 7300 Computer 97