Asante Technologies 5212 user manual Factory Defaults

Introduction

Factory

Defaults

The IntraSwitch 5212 is shipped with the following configuration default settings:

Table 1-2 Factory Default Configurations

Configuration	Default Setting
IP address	0.0.0.0
	Important! The first IP address that is
	assigned to the IntraSwitch becomes the new
	factory default setting.
Subnet Mask	0.0.0.0
	Important! The first subnet mask that is
	assigned to the IntraSwitch becomes the new
	factory default setting.
Default Gateway	0.0.0.0
	Important! The first default gateway
	address that is assigned to the IntraSwitch
	becomes the new factory default setting.
Switching Mode	Store-and-forward
10Base-T Ports	Half duplex
10/100TX Port and	Auto-negotiation
Asanté MII
Expansion Port
Spanning Tree	Enabled on ALL ports

▲Important! When the IntraSwitch 5212 is reset (powered off and then on), all settings are returned to the factory defaults listed above except for the IP Address, Subnet Mask, and Default Gateway; these items revert to the first addresses assigned to them.

Page 1-10