Avaya 1220 manual Attaching the foot stand optional, Connecting the handset

Installing your Avaya 1220 IP Deskphone

Attaching the foot stand (optional)

Attach the foot stand in the appropriate slots depending on the desired angle for your Avaya 1220 IP Deskphone. If you insert the foot stand into the upper slots, your IP Deskphone sits at a 25-degree angle. If you insert the foot stand into the lower slots, your IP Deskphone sits at a 55-degree angle.

If you install your IP Deskphone on a wall, do not attach the foot stand.

1.Align the bottom tabs on the foot stand with the position 1 slots or the position 2 slots on the back of your IP Deskphone.

In position 1 the IP Deskphone sits at a 25-degree angle. In position 2 the IP Deskphone sits at a 55-degree angle.

Figure 4 on page 36 shows the slots on the back of the IP Deskphone.

2.Press the foot stand into the slots until it snaps into place.

Connecting the handset

Use the following procedure to connect the handset to the Avaya 1220 IP Deskphone.

1.Plug the end of the handset cord with the short straight section into the handset.

2.Plug the other end of the handset cord with the long straight section into the handset jack marked with the + symbol on the back of the IP Deskphone.

3.(Optional) Thread the cord through the channel in the foot stand (if installed) so that it exits on the side of the foot stand.

Figure 4 on page 36 shows the connections on the back of the Avaya 1220 IP Deskphone.

37