Turning the system on and verifying POST
Issue 3.3 February 2003 47
8. Enter:
probe-ide
This verifies that the system sees all enhanced integrated drive electronics (EIDE)
devices. A message similar to the following is displayed:
In this example, the devices listed are as follows:
●Device 0 is the primary internal hard drive.
●Device 1 is the optional second internal hard drive, if present.
●Device 2 is the CD-ROM drive.
●Device 3 is the floppy drive, if present.
Note:
Note: The actual devices listed depends on the devices installed on the EIDE bus.
9. Enter:
reset-all
The system resets to the ok prompt.
Device 0 ( Primary Master )
ATA Model: STxxxxxx
Device 1 ( Primary Slave )
Not Present (or) ATA Model: STxxxxxx
Device 2 ( Secondary Master )
Removable ATAPI Model: CRD-xxxxx
Device 3 ( Secondary Slave )
Not Present (or) Removable ATAPI Model: xxxx