Maintaining disk drives
Issue 3.3 February 2003 107
SCSI devices are addressed as shown in the following table.
The addresses are set using the target address switches on the back of each SCSI device.
Before setting the target address, make sure that the power is off on the SCSI devices.
Device Address
Disk drive 1 0
Disk drive 2 1
Disk drive 3 2
Disk drive 4 3
Tape drive 1 4
Tape drive 2 5
!Important:
!Important:
Important: Do not use a target address
greater than 5.
Pressthis side to increase
theaddress number.
Pressthis side to decrease
theaddress number.
+
2
scsiidsw.cdr