![](/images/new-backgrounds/1210647/210647105x1.webp)
Telephone Installation | Wall Mounting 2000 Series Telephones - Page 53 |
Wall Mounting 2000 Series Telephones
Mounting brackets exist which clip onto the base on IP Office telephones. These brackets (two required per telephone) can be used to either raise the desk position of the telephone or for wall mounting. Before wall mounting a telephone, check that the surface is flat, vertical and not subject to movement or vibration.
To wall mount an IP Office telephone :
1.Using the dimensions given below, mark the position for the screw holes. Ensure that adequate clearance above and below the telephone is allowed.
2.Drill the necessary holes and insert the wall plugs.
3.Insert the screws, leaving the heads approximately 3mm proud of the surface (check by clipping a bracket over the screw head).
4.Attach the brackets to the telephone. Then slide the bracket
5.Reverse the position of the handset retainer tab (located below the hook switch on the telephone). This keeps the handset in place whilst the telephone is mounted on the wall.
Additional Items : | IP Office 2030/50 | IP Office 2010 , IP Office |
– Two No. 8 Pan head o | Telephones | 20AT Telephones (Not to |
Round head screws. | (Not to scale) | scale) |
– Two wall plugs. |
|
|
– Drill and drill bit. |
|
|
– Screwdriver. |
|
|
IP Office Installation Manual | Telephone Installation - Page 53 |
40DHB0002USCL – Issue 9 (28th October 2003) | Wall Mounting 2000 Series Telephones |