Using the Web-Based Advanced User Interface
Table of Contents | sections | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 |
Setting Up a Bridge Between your Router and a Secondary Access Point
Bridging your Belkin Router to a secondary Access Point requires that you access the Router’s Advanced Setup Utility and enter the MAC address of the Access Point in the appropriate area. There are also a few other requirements. PLEASE BE SURE TO FOLLOW THE STEPS
BELOW, CAREFULLY.
1.Set your Access Point to the same channel as the Router. By default, the Router and Access Point channels are set to channel 11 at the factory. If you have never changed the channel, you don’t need to do anything (for more information on changing channels, see page 48 of this User Manual).
2.Find the Access Point’s MAC address on the bottom of the Access Point. There are two MAC addresses on the bottom label. You will need the MAC address named “WLAN MAC Address”. The MAC address starts with 0030BD and is followed by six other numbers or letters (i.e.
NC8E&C8ED8:8[[i\jj1
N`i\c\jj>Le`m\ijXc J\i`XcEf1 IXe^\<ok\e[\i 
Df[\c1=,;.(*)
=::@;1B.J=,;.(*)8
'+.' 
Q,)/
9\cb`e =,;.(*)
K\jk\[kf:fdgcp n`k_=::JkXe[Xi[j
=FI?FD<FIF==@:<LJ<
G('.0.
m\ij`fe DX[\`eKX`nXe ;\j`^e\[`e:Xc`]fie`X
G Wireless Router | 62 |
