26 en Hardware setup | Divar 700 Series |
|
|
Placing a hard disk
Figure 4.4 Placing a hard disk
1.Locate the first empty hard disk bay. It is recommended to install the disks in order from one to four, as labeled. (Note that disks 3 and 4 are mounted in a double bay.)
2.Unscrew the two torx T10 screws securing the selected bay. Slide the bay from the unit by pulling it forward.
3.To replace an installed hard disk, remove the four installation screws, two per side, from the sides of the bay. Remove the hard disk.
Mount the new hard disk into the bay with four screws, two per side (refer to the hard disk documentation).
4.Align and slide the bay back fully into its slot in the unit.
5.Secure the bay using the two torx T10 screws removed earlier (step 2).
6.Repeat steps
Remounting the front panel
1.When disk installation is complete, reconnect the flat cable to the front panel, if necessary.
2.Align and slide the front panel to the left until it is in place.
3.Refasten the two captive cross head screws to the front panel.
The location of the hard disks is not important; the unit can determine in which bay they are installed. When installing hard disks that have recordings from another unit, the recorder detects this and puts these drives in
Refer to Section 6.10 Storage, page 96 for the correct configuration procedure.
F.01U.246.471 v3.6 2011.11 | Installation and Operation manual | Bosch Security Systems |
