Bosch Appliances 700 operation manual 6.6.2, Motion detection on IP cameras

Divar 700 SeriesAdvanced configuration en 83

6.6.2	Motion detection on IP cameras
	With IP cameras there are two ways of performing motion detection:
	–	in the camera, or
	–	in the recorder.

Figure 6.13 Configuration menu - Motion on IP cameras

To enable motion detection in the camera:

1.Click the Change button until the Motion detection by field shows Camera.

– Now the Divar only receives a motion detected event from the camera.

2.Use the camera browser interface to select the type of motion detection algorithm (IVA

or Motion+) and configure the motion detection features of the camera.

Both IVA and Motion+ events are reported to the recorder as a motion detected event. The recorder does not record IVA metadata nor support IVA-specific events such as line crossing. To set motion detection by DVR:

1.Click the Change button until the Motion detection by field shows DVR.

2.Use the drawing area trigger level to configure the DVR motion detection, just as

described for analog cameras.

No detection features of the camera itself are used.

Note:

The settings on this page only become effective after clicking the Save button.

Bosch Security Systems Installation and Operation manual F.01U.246.471 v3.6 2011.11