Bosch Appliances 700 6.5Contacts, 6.5.1, 6.5.2, Relay outputs, 6.5.3, Contact input properties

Divar 700 Series Advanced configuration en 79

6.5Contacts

Use the Contacts menu to set up alarm inputs and relay outputs.

	Figure 6.11 Configuration menu - Contacts
6.5.1	Contact inputs
	By default, all contact Inputs are Normally Open (NO). When needed, highlight contact inputs
	to function as Normally Closed (NC) contacts (highlight the un-numbered box to select all).
	Note:
	If an IP camera is attached to the unit, physical contact input 1 of the IP camera is ORed with
	the similarly numbered physical contact input. This ORed level is used as alarm or event
	source. For example, if camera 3 is an IP camera then its contact input is ORed with the
	recorder contact input number 3. Contact inputs other than contact 1 are ignored by the
	recorder.
6.5.2	Relay outputs
	By default, all relay output contacts are Normally Open (NO). When needed, highlight the relay
	outputs to function as Normally Closed (NC) contacts.
	Note:
	The local interface does not provide control over relay outputs on IP devices.
6.5.3	Contact input properties
	Each of the 16 contact inputs can be assigned a name and a profile override mode.

Profile overrides

An alarm input can activate a profile override. There are three modes available:

Bosch Security Systems Installation and Operation manual F.01U.246.471 v3.6 2011.11