Divar 700 Series | Advanced configuration en 69 |
|
|
Control tab
–Enable PTZ when a controllable camera is connected. By default, PTZ is disabled.
–Select protocol and device address on PTZ bus. (PTZ commands are transmitted across the RS485 and Biphase bus simultaneously. Each camera should have a unique address greater than 0.)
6.2.2IP Channels
A General tab and a Control tab are available for each camera.
Note:
An IP stream must only be connected to a single channel on a single Divar. There should be no connection to any other device that could influence the settings of the IP device.
Figure 6.5 Configuration menu - Video & Audio - IP camera
IP camera
If an IP connection has already been configured, the IP address, input type, and stream number is displayed. If a connection has already been established, a video preview appears.
Note:
The Divar will overrule the encoder profile set in the camera itself if required by the following settings.
Bosch Security Systems | Installation and Operation manual | F.01U.246.471 v3.6 2011.11 |
