Bosch Appliances 700 Monitor streaming connection hybrid version, 4.6.2CVBS, 4.6.3Y/C

Divar 700 Series Hardware setup en 29

4.6.2CVBS

Connect the unit to CCTV monitors using 75 ohm video coaxial cables with BNC connectors. The unit provides a 1 Vpp CVBS signal.

If the monitor has a loop-through connection without using the loop-through output, then select the 75 ohm impedance setting on the monitor. If the monitor's loop-through output is connected to an additional device, the device's termination is set to 75 ohm and the monitor's termination is set to high impedance. (This is not necessary on devices with automatic termination.)

Specifications

Output signal: Composite video 1Vpp, 75 ohm, Sync. 0.3Vpp ±10%

Resolution: 704 x 576 PAL, 704 X 480 NTSC

Connector type: BNC

B

A

CVBS

Figure 4.9 CVBS monitor connectors (hybrid version)

4.6.3Y/C

Connect the unit to a CCTV monitor with Y/C input, using a standard Y/C connection cable.

B

A

Y/C

Figure 4.10 Y/C monitor connectors (hybrid version)

4.7 Monitor streaming connection (hybrid version)

To connect a monitor in a remote streaming configuration, connect the CVBS monitor output to a video input. Then connect the monitor to the corresponding loop-through connector.

	KBD in		Ethernet			B	B	B							1	3	5	7	9	11	13	15
- + G
RS													L
485									Com 1			Com 2
						A	A	A
MAL													R
OUT													A	B	2	4	6	8	10	12	14	16
N0 C NC	KBD out	USB	USB		IR ext	VGA	Y/C		Biphase			Alarm I/O
						Monitor out							Audio out		Audio in
	AC	1	2	3	4	5	6	7	8	9	10	11	12		13	14	15	16
						Video in			Video in				Video in
		1	2	3	4	5	6	7	8	9	10	11	12		13	14	15	16
						Video out			Video out				Video out

AB

Figure 4.11 Typical monitor streaming connection (hybrid version)

Bosch Security Systems Installation and Operation manual F.01U.246.471 v3.6 2011.11