The fast preheat icon&appears in the display just above the mode name.
2.Press Start.
Fast Preheat can be turned off by pressing Fast Preheat again.
Special Features
The special features provide you with additional conveniences when cooking.
Learn more about these special features in the following sections:
•Probe (some models)
•Sabbath Mode
•Panel Lock
Probe (some models)
The probe measures the internal temperature of the food. The probe is available for Bake, Roast and all convection cooking modes except Convection Broil.
Inserting the probe:
Insert the tip of the probe in the middle and thickest part of the meat. Make sure the probe is not touching fat, bone, or parts of the oven or the pan.
To use the probe:
1.Insert the probe into the meat as described above.
2.Connect the probe to the oven. If the probe is not connected to the oven prior to starting Probe mode, an error tone sounds and the message “INSERT PROBE” is displayed.
3.The Set Probe Temp screen is displayed. A three digit input prompt “- -
4.Set the cooking mode and temperature.
Note: The minimum probe temperature that can be set is 100° F (40° C) and the maximum is 200° F (100° C).
If the probe temperature entered is outside this range, an error is displayed.
5.The probe current temperature and target temperature are both displayed in the format “105 / 180” at the lower right corner of the display. The actual temperature will display < 80 until the food temperature reaches 80³ F.
The displayed probe temperature is updated in increments of 5° during the cooking process.
6.When the probe temperature reaches the set temperature, the cooking mode turns off. The current time is displayed and the message “COOKING COMPLETE” blinks at the bottom left of the display. An alarm tone sounds every 10 seconds for 2 minutes.
This screen remains in the display until it is cleared by pressing the Oven Clear/Off touchpad or until the probe is removed. The display then goes back to stand by mode.
Note:
•Probe is not available when an Oven Timer has been set.
•To change the probe temperature press the Probe touchpad. The display enters probe temperature editing mode and displays the message “SET PROBE TEMP”. Enter the new probe temperature and press Enter to accept the new value.
•Do not store the probe in the oven.
•Always use the handle of the probe for inserting and removing.
•Always use a potholder to remove the probe since it becomes hot.
English 18
